Atm Policy - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

atm policy

Syntax
Release Information
Description
Options
Mode
Related Topics
178
atm policy { input | output } policyName
[ statistics { enabled [ preserve | merge ] | disabled [ merge ] } | merge ]
no atm policy { input | output } [ policyName ]
Command introduced in JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Assigns a policy list to the ingress or egress of an ATM interface. If you enter this command
when the policy list does not exist, the router creates a policy list with a filter rule as the
default. You must specify the input or output keyword to assign the policy list to the
ingress or egress of the interface. The no version removes the association between a
policy list and an interface.
input—Applies policy to data arriving at this interface
output—Applies policy to data leaving this interface
policyName—Name of the policy; a maximum of 40 characters
statistics—Enables or disables collection of policy routing statistics
enabled—Enables collection of policy routing statistics
preserve—Preserves existing statistics for any classifier-list that is the same for both
the new and old policy attachments when you attach a new policy to an interface
disabled—Disables collection of policy routing statistics
merge—Enables merging of multiple policies to form a single policy
Interface Configuration
Setting a Statistics Baseline for Policies
Copyright © 2010, Juniper Networks, Inc.