Duplex - H3C S7500E Series Command Reference Manual

If you provide no argument or keyword, this command displays all storm control settings on all storm
control-enabled interfaces.
Examples
# Display the storm control settings on all storm control-enabled ports.
<Sysname> display storm-constrain
Abbreviation: BC - broadcast; MC - multicast; UC - unicast
Flow Statistic Interval: 5(second)
PortName Type LowerLimit UpperLimit CtrMode Status Trap Log SwiNum Unit
------------------------------------------------------------------------------
GE2/0/1 BC
Table 1-10 display storm-constrain command output description
Field
Flow Statistic Interval
PortName
Type
LowerLimit
UpperLimit
CtrMode
Status
Trap
Log
Swinum

duplex

Syntax
duplex { auto | full | half }
undo duplex
11 1111 N/A
The traffic polling interval of the storm control module.
Abbreviated port name
Type of traffic subjected to storm control. Options include broadcast, multicast
and unknown unicast.
Lower storm control threshold, in pps, kbps, or percentage.
Upper storm control threshold, in pps, kbps, or percentage.
Protective action taken on the port when the upper threshold is reached,
which can be block or shutdown. If you have not configured any protective
action, N/A is displayed.
Packet forwarding status, which may be one of the following:
normal – The port is forwarding traffic normally.
control – The port is in controlled mode (the actual mode depends on the
Ctrmode setting, which may be block or shutdown).
Status of the storm control threshold event trap switch:
on – The port sends threshold event traps.
off – The port does not send threshold event traps.
Status of the storm control threshold event log switch:
on – The port sends threshold event log messages.
off – The port does not send threshold event log messages.
Number of times the forwarding state of the interface changes.
When the Swi-num count reaches 65,535, it resets automatically.
normal on on 0
Description
1-20
pps