Duplex - H3C s3600 series Command Manual

Description :
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000f-e290-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total):
0 broadcasts, 0 multicasts, 0 pauses
Input(normal):
- broadcasts, - multicasts, - pauses
Input: 0 input errors, 0 runts, 0 giants,
0 frame,
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors,
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
(The following displayed information is omitted)
Table 1-8 Description on the fields of the display unit command
Aux1/0/0
Description : Aux Interface
For the description of other fields, refer to

duplex

Syntax
duplex { auto | full | half }
Aux Interface
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
- packets, - bytes
- overruns, 0 aborts, 0 ignored, - parity errors
- underruns, - buffer failures
Field
- throttles, 0 CRC
Description
The description string of the AUX port is Aux Interface.
Table 1-4.
1-15