Duplex - H3C S5120-SI Series Command Reference Manual

Table 1-4 display storm-constrain command output description
Field
Flow Statistic Interval
PortName
StormType
LowerLimit
UpperLimit
CtrMode
Status
Trap
Log
Swinum

duplex

Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet port view
Default Level
2: System level
Parameters
auto: Indicates that the interface is in auto-negotiation state.
full: Indicates that the interface is in full-duplex state.
half: Indicates that the interface is in half-duplex state. The optical interface of a SFP port does not
support the half keyword.
Description
Use the duplex command to configure the duplex mode for an Ethernet port.
Use the undo duplex command to restore the duplex mode for an Ethernet port to the default.
By default, the duplex mode for an Ethernet port is auto.
Related commands: speed.
Interval for generating storm constrain statistics
Abbreviated port name
Type of the packets for which storm constrain function is enabled,
which can be broadcast (for broadcast packets), multicast (for
multicast packets), and unicast (for unicast packets).
Lower threshold (in pps, kbps or percentage)
Upper threshold (in pps, kbps or percentage)
Action to be taken when the upper threshold is reached, which can be
block, shutdown, and N/A.
Interface state, which can be normal (indicating the interface operates
properly), control (indicating the interface is blocked or shut down).
State of trap messages sending. "on" indicates trap message sending
is enabled; "off" indicates trap message sending is disabled.
State of log sending. "on" indicates log sending is enabled; "off"
indicates log sending is disabled.
Number of the forwarding state switching.
This field is numbered modulo 65,535.
1-12
Description