Table of Contents
Advertisement
Application Notes to Use Boot ROM
Figure 6-36. LM FLASH Programmer Serial Interface Configuration Screen
2. Select the Program tab as shown below and select the bin file built as explained in
The Program Address Offset in the snapshot below is the LOAD address for M-Boot ROM to load the
application. The same address is the Application START address. The 'Reset MCU After Program'
option has to be selected for the application to be automatically started after load is complete. This
option doesn't reset the MCU, but will send the RESET packet to the M-Boot ROM bootloader which
will start executing the application code just downloaded.
662
ROM Code and Peripheral Booting
Copyright © 2012–2019, Texas Instruments Incorporated
Section
SPRUHE8E – October 2012 – Revised November 2019
Submit Documentation Feedback
www.ti.com
6.8.1.1.
Advertisement
Chapters
Table of Contents
