Table of Contents
Advertisement
Application Notes to Use Boot ROM
Figure 6-38. LM FLASH Programmer EMAC Interface Selection Screen
2. Select the program tab as shown below and select the binary image file built as shown in
Section
6.8.1.1.
Note: There is no way for the user to control where in the master subsystem RAM, the application
should get loaded. It is fixed at M_BOOT_ROM_RAM_ENTRY_POINT as explained in
664
ROM Code and Peripheral Booting
Copyright © 2012–2019, Texas Instruments Incorporated
SPRUHE8E – October 2012 – Revised November 2019
Submit Documentation Feedback
www.ti.com
Section 6.5.7.5
Advertisement
Chapters
Table of Contents
