Stt Settings - Texas Instruments OMAP5910 Technical Reference Manual

Hide thumbs Also See for OMAP5910:

Table of Contents

Stop Condition (STP)

Start Condition (STT)

Table 7–65. STT Settings

Master mode only.

This bit (1) can be set to a 1 by the local host to generate a stop condition. It

is reset to 0 by the hardware after the stop condition has been generated. The

stop condition is generated when DCOUNT passes 0.

0: No action or stop condition detected

1: Stop condition queried

Value after reset is low.

Master mode only.

This bit (0) can be set to a 1 by the local host to generate a start condition. It

is reset to 0 by the hardware after the start condition has been generated. The

start/stop bits can be configured to generate different transfer formats. The

STT and STP can be used to terminate the repeat mode.

0: No action or start condition generated

Value after reset is low.

Start/stop (COUNT= n)

Start (DCOUNT= n)

DCOUNT is data count value.

Inter-Integrated Circuit Controller

Bus Activities

S-A-D..(n)..D-P

S-A-D..(n)..D

MPU Public Peripherals