Transmission Range Sensor Inspection And Adjustment - Suzuki SX4 Service Manual

2) Turn ignition switch to ACC position.
3) Insert cable casing cap (1) into key cylinder cover (2)
securely.
1
4) Pull out lock button (1) of select lever side cable end
(2).
5) Shift select lever to "N" position.
NOTE
If select lever is in "P" position, shift select
lever referring to "Select Lever Inspection".
6) Install cable casing cap (3) to bracket (4).
7) Connect cable end (1) to interlock cam (2) with
ignition switch turned to ACC position.
8) Drive lock button (5) in cable end until it locks cable
expansion and contraction.
2
1
2
I5RW0C510047-01
2
1
1
I2RH01510086-01
5
3
3
4
I5RW0C510048-01
Automatic Transmission/Transaxle:
9) With select lever set at "P" position, turn ignition key
to ACC position and then check for the following
conditions.
• With knob button released, ignition key can be
turned from ACC position to LOCK position.
• With knob button pressed, ignition key cannot be
turned from ACC position to LOCK position.
10) Install knee protector to steering column.
11) Install steering column cover.
12) If the vehicle is equipped with air bag system,
connect negative cable at battery and enable air bag
system, referring to "Enabling Air Bag System in
Section 8B".
Transmission Range Sensor Inspection and
Adjustment
1) Shift manual select lever (4) to "N" range.
2) Check that needle direction shaped on lock washer
(2) and "N" reference line (1) on transmission range
sensor are aligned. If not, loosen sensor bolts (3)
and align them.
Tightening torque
Transmission range sensor bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
4
5A-91
S7RW0A5106015
1
2
3, (a)
I2RH0B510041-01