Condenser Cooling Fan Inspection
1) Check condenser cooling fan motor for resistance
between terminal "a" and "b" as shown.
If there is no continuity, replace condenser cooling
fan motor.
2) Connect battery to condenser cooling fan motor
terminal "a" and "b" as shown in figure, and then
check if the condenser cooling fan motor operates
smoothly.
Reference
Condenser cooling fan specified current at 12 V:
7 A maximum
Condenser Assembly On-Vehicle Inspection
S7RW0A7216003
Check the followings.
• Clog of condenser fins
• Condenser fins for leakage and breakage
a
b
• Condenser fittings for leakage.
Condenser Assembly Removal and Installation
I5RW0A721018-02
Removal
a
b
I5RW0A721019-02
Air Conditioning System: Manual Type 7B-23
If any clog is found, condenser fins should be washed
with water and should be dried with compressed air.
If any defects are found, repair or replace condenser.
If any defects are found, repair or replace condenser.
CAUTION
!
Do not damage condenser fins. If condenser
fin is bent, straighten it by using flat head
screwdriver or pair of pliers.
1) Recover refrigerant from A/C system referring to
"Operation Procedure for Refrigerant Charge:
Manual Type".
NOTE
The amount of removed compressor oil must
be measured for replenishing compressor
oil.
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Disconnect discharge hose (1) and liquid pipe (2)
from condenser assembly (3).
4) Remove radiator assembly and condenser assembly
mounting bolts (4).
1
2
3
4
S7RW0A7216004
S7RW0A7216005
4
I7RW01721025-04
Need help?
Do you have a question about the SX4 and is the answer not in the manual?
Questions and answers