Download Table of Contents Print this page

Suzuki SX4 Service Manual page 1215

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
The adapter (1) will also give an idea of whether or not
contact tension is sufficient, helping to find an open or
intermittent open due to poor terminal contact. An SDM
short bar release tool (2) is included in the connector test
adapter kit. Inserting it into the SDM connector (3) will
releases the shorting bar.
3
Special tool
(B): 09932–75010 Air bag driver / passenger load
tool
This tool is used as a diagnostic aid and safety device to
prevent inadvertent air bag (inflator) module deployment.
The load tool has three connectors attached to its case
which are electrically functional and serve as resistive
load substitutions.
No more than two connectors are used at any time.
One of connectors ("STEERING WHEEL") is used to
substitute the load of the followings.
• Driver air bag (inflator) module when it is connected at
the top of the column to the contact coil assembly.
• Passenger air bag (inflator) module when it is
connected to the air bag harness connector in
instrument panel harness for passenger air bag
(inflator) module.
• Each of driver and passenger seat belt pretensioners
when it is connected to air bag harness connector in
instrument panel harness for driver and passenger
seat belt pretensioners.
• Side-air bag (inflator) module when it is connected to
the floor harness connector for side-air bag (inflator)
module.
• Side curtain-air bag (inflator) module when it is
connected to the floor harness connector for side
curtain-air bag (inflator) module.
Another connector ("BASE OF COLUMN") is used to
substitute the load of the driver air bag (inflator) module
and the contact coil assembly when it is connected at the
base of the column to the air bag wire harness.
The third connector ("PASSENGER INFLATOR") is not
used.
By substituting the resistance of the load tool when
called for, a determination can be made as to whether an
inflator circuit component is causing system malfunction
and which component is causing the malfunction.
1
The load tool should be used only when specifically
called for in the diagnostic procedures.
2
I4RS0A820108-01
1. Connector for contact coil and driver air bag (inflator) module
2. Connector for driver, passenger air bag (inflator) module, side-air bag
3. Not used
Air Bag System:
(Located near the base of the steering column)
(inflator) module and driver and passenger seat belt pretensioners
8B-122
I1JA01820004-01

Advertisement

Table of Contents
loading

Table of Contents