Transmission Range Sensor (Shift Switch) Inspection And Adjustment - Suzuki Liana RH418 Supplementary Service Manual

5A-68 Automatic Transmission/Transaxle:
5) Shift selector lever to "N" position.
6) Apply grease to selector lever pin and install adjuster
(cable end) to it.
: Grease 99000–25010
7) With both selector lever and transmission range
sensor kept each "N" position, drive cable end holder
(1) in until it locks cable.
8) Slide lock plate (2) to secure cable end holder in
position.
9) After select cable was installed, check for the
following.
• Push vehicle with selector lever shifted to "P"
range. Vehicle should not move.
• Vehicle can not be driven in "N" range.
• Vehicle can be driven in "D", "2" and "L" ranges.
• Vehicle can be backed in "R" range.
Transmission Range Sensor (Shift Switch)
Inspection and Adjustment
Inspection
1) Disconnect transmission range sensor connector
(1).
2) Check that continuity exists at terminals shown in the
following figure by moving selector lever.
I2RH01510048-01
Adjustment
1) Shift manual shift lever (1) to "N" range.
2) Connect ohmmeter between 7 and 9 terminals of
disconnected transmission range sensor connector
(3).
3) Turn transmission range sensor (2) gradually to find
position where ohmmeter reading indicates
continuity. Then fix transmission range sensor (2) at
that position by tightening bolts to specified torque.
Tightening torque
Transmission range sensor bolt (a): 25 N·m (2.5
kgf-m, 18.0 lb-ft)
4) Connect transmission range sensor connector (3).
Terminal No.
1 2 3 4 5 6
P
R
N
D
2
L
S3RH0B5106008
1
7 8 9
I3RH0B510024-01