Water Pump Removal And Installation - Suzuki SX4 Service Manual

Hide thumbs

Advertisement

Table of Contents
Installation
1) Install belt (1) to water pump pulley (2), crankshaft
pulley (3) and generator pulley (4).
2) Adjust belt tension referring to "Water Pump /
Generator Drive Belt Tension Inspection and
Adjustment".
3) If vehicle equipped with A/C, install compressor drive
belt referring to "Compressor Drive Belt Removal
and Installation: Manual Type in Section 7B" or
"Compressor Drive Belt Removal and Installation:
Automatic Type in Section 7B".
4
4) Connect negative cable at battery.

Water Pump Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Drain coolant.
3) Remove water pump / generator drive belt referring
to "Water Pump / Generator Drive Belt Removal and
Installation".
4) Remove water pump pulley.
5) Remove water pump assembly (1).
Installation
1) Apply sealant to mating surface of water pump (1) as
2
1
2) Install water pump assembly (1) to cylinder block
3
I5RW0C160009-01
S7RW0A1606017
3) Install water pump pulley.
4) Install water pump / generator drive belt referring to
5) Install A/C compressor belt referring to "Compressor
6) Refill cooling system referring to Step 7) to 17) of
I5RW0C160011-01
7) Connect negative cable at battery.
8) Check each part for leakage.
Engine Cooling System:
shown in figure.
"A": Water tight sealant 99000–31250 (SUZUKI
Bond No.1207F)
Sealant quantity (to mating surface of water
pump)
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
and tighten bolts and nut to specified torque.
Tightening torque
Water pump bolt and nut (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
"Water Pump / Generator Drive Belt Removal and
Installation".
Drive Belt Removal and Installation: Manual Type in
Section 7B" or "Compressor Drive Belt Removal and
Installation: Automatic Type in Section 7B".
"Cooling System Flush and Refill".
1F-11
I3RM0A160016-01
I5RW0C160010-01

Advertisement

Table of Contents
loading

  Also See for Suzuki SX4

Table of Contents