Disabling Air Bag System
NOTE
With "A/B" fuse removed and ignition switch
ON, "AIR BAG" warning light will be ON.
This is normal operation and does not
indicate air bag system malfunction.
1) Turn steering wheel so that vehicle's wheels (front
tires) are pointing straight ahead.
2) Disconnect negative (–) cable at battery.
3) Turn ignition switch to "LOCK" position and remove
key.
4) Remove "A/B" fuse from junction block assembly.
5) Remove driver side front pillar lower trim and
disconnect yellow connector (1) for driver air bag as
follows.
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
6) Remove passenger side front pillar lower trim and
disconnect yellow connector (3) for passenger air
bag as follows.
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
1
3
7) Disconnect yellow connector of side-air bag (inflator)
module under front seat cushion (1).
a) Release locking of lock slider (2).
b) After unlocked, disconnect connector.
Repair Instructions
S7RW0A8206001
a)
b)
2
I7RW01821012-01
2
a)
b)
8) Disconnect connector of side curtain-air bag
(inflator) module as follows.
For hatchback model:
a) Remove right-side rear quarter lower trim.
b) Release locking of lock slider (2) of yellow
connector (1).
c) With unlocked, disconnect connector.
1
For sedan model
a) Remove rear side sill scuff referring to step 3) of
"Floor Carpet Removal and Installation in
Section 9H".
b) Remove rear seat side back.
c) Remove rear pillar inner trim.
d) Unlock lock button (2) of black connector (1).
e) With lock button unlocked, disconnect connector.
e)
2
d)
1
Air Bag System:
8B-94
1
I6RW0B820017-01
b)
a)
2
I6RW0B820018-01
I7RW0A820004-01