Select Cable Components; Select Cable Removal And Installation; Select Cable Adjustment - Suzuki SX4 Service Manual

5A-88 Automatic Transmission/Transaxle:

Select Cable Components

11
2
[A]
[A]
(a)
3
[A]: View [A]
[B]: View [B]
1. Select lever assembly
2. Select cable
3. Cable bracket
4. Manual select lever

Select Cable Removal and Installation

Removal
1) Remove console box referring to "Console Box
Components in Section 9H".
2) Disconnect select cable from select lever and then
detach from bracket.
3) Remove clip and disconnect select cable from
manual select lever.
4) Remove select cable retainer from dash panel.
Installation
Install select cable by reversing removal procedure.
The important steps in installation are as follows.
• Apply grease to pin and cable joint.
• Tighten bolts to specified torque referring to "Select
Cable Components".
[B]
(b)
4
5
6
A
5. Clip
6. Manual select lever pin
: Apply lithium grease 99000-25011 to all around pin (0.15 g)
7. Select lever pin
: Apply lithium grease 99000-25011 to all around pin (0.15 g)
8. Adjuster case
9. Lock
10. P/S control module
S7RW0A5106012
9
8
10
[B]
• Adjusting procedure is as follows. Refer to "Select
Cable Adjustment".

Select Cable Adjustment

1) Shift manual shift lever to "N" range (transmission
range sensor "N" range).
"N"
"R"
"P"
S7RW0A5106011
7
A
1
(c)
I5RW0C510031-01
11. Radiator inlet hose
: 23 N⋅m (2.0 kgf-m, 17.0 lb-ft)
: 6.5 N⋅m (0.65 kgf-m, 5.0 lb-ft)
: 13 N⋅m (1.3 kgf-m, 9.5 lb-ft)
S7RW0A5106013
"D"
"2"
"L"
I2RH0B510040-01