72) After applying A/T fluid to new O-ring, fit it to valve
body harness connector (3), then install valve body
harness to transaxle case.
CAUTION
!
When put valve body harness (1) into
transaxle case, take care not to damage
transmission fluid temperature sensor (2) at
narrow entrance of case.
Careless sensor treatment might cause
sensor malfunction.
Tightening torque
Valve body harness connector bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
73) Install manual valve rod (1) to manual valve lever (3)
and then install valve body assembly (2) to transaxle
case.
74) Tighten valve body bolts to specified torque.
Tightening torque
Valve body bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Automatic Transmission/Transaxle:
Valve body bolt length
Bolt
A (1)
B (2)
C (3)
D (4)
E (5)
75) Connect solenoid connectors to solenoid valves
identifying their installing positions by wire colors,
and install transmission fluid temperature sensor to
its clamp.
Solenoid valve coupler specification
Solenoid valve coupler
Shift solenoid valve-A (No.1) (1)
Shift solenoid valve-B (No.2) (2)
I2RH0B510321-01
Timing solenoid valve (3)
TCC solenoid valve (4)
Pressure control solenoid valve (5)
Transmission fluid temperature
sensor (6)
I2RH0B510322-01
Length "a"
20 mm (0.79 in.)
28 mm (1.10 in.)
49 mm (1.93 in.)
36 mm (1.42 in.)
40 mm (1.58 in.)
4
6
3
5A-159
Pieces
6
5
1
1
1
I2RH0B510323-01
Wire color
White
Black
Yellow
Light green /
Brown
Gray / Green
Orange
5
2
1
I5RW0C510067-02