Valves And Valve Guides Inspection - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:
Table of Contents

Advertisement

Valves and Valve Guides Inspection

Valve Guide
Valve stem-to-guide clearance
Using a micrometer and bore gauge, take diameter readings on valve stems and guides to check stem-to-guide
clearance.
Be sure to take reading at more than one place along the length of each stem and guide.
If clearance exceeds limit, replace valve and valve guide.
Valve stem and valve guide specification
Item
Valve stem diameter [A]
Valve guide bore [B]
Stem-to-guide clearance
Valve stem end deflection
If bore gauge is not available, check end deflection of
valve stem with a dial gauge instead.
Move stem end in directions (1) and (2) to measure end
deflection.
If deflection exceeds its limit, replace valve stem and
valve guide.
Valve stem end deflection limit
In: 0.14 mm (0.005 in.)
Ex: 0.18 mm (0.007 in.)
In
5.465 – 5.480 mm (0.2150 – 0.2157 in.)
Ex
5.440 – 5.455 mm (0.2142 – 0.2148 in.)
In & Ex
5.500 – 5.512 mm (0.2165 – 0.2170 in.)
In
0.020 – 0.047 mm (0.0008 – 0.0018 in.)
Ex
0.045 – 0.072 mm (0.0017 – 0.0028 in.)
IYSQ01141096-01
Standard
Valve
Visual inspection
• Remove all carbon from valves.
• Inspect each valve for wear, burn or distortion at its
face and stem end, as necessary, replace it.
• Inspect valve stem end face for pitting and wear. If
pitting or wear is found there, valve stem end may be
resurfaced, but not too much to grind off its chamber.
When it is worn out too much that its chamber is gone,
replace valve.
Engine Mechanical:
1D-45
S7RW0A1406027
Limit
0.070 mm (0.0028 in.)
0.090 mm (0.0035 in.)
I4RS0B140016-01
I2RH01140135-01

Advertisement

Table of Contents
loading

Table of Contents

Save PDF