5) Install cylinder head to cylinder block.
Apply engine oil to new cylinder head bolts and
tighten them gradually as follows.
a) Tighten cylinder head bolts ("1" – "10") to 20 N⋅m
(2.0 kgf-m, 14.5 lb-ft) according to numerical
order as shown by using a 12 corner socket
wrenches.
b) In the same manner as in Step a), tighten them
to 40 N⋅m (4.0 kgf-m, 29.0 lb-ft).
c) Turn all bolts 60° according to numerical order in
figure.
d) Repeat Step c).
e) Tighten cylinder head bolt (M8) (1) to specified
torque.
NOTE
Be sure to tighten M8 bolt (1) after securing
the other bolts.
Tightening torque
Cylinder head bolt for M8 (a): Tighten 25 N⋅m
(2.5 kgf-m, 18.0 lb-ft) by the specified
procedure
Cylinder head bolt for M10 (b): Tighten 20
N⋅m (2.0 kgf-m, 14.5 lb-ft), 40 N⋅m (4.0 kgf-m,
29.0 lb-ft), 60° and 60° by the specified
procedure
NOTE
• If cylinder head bolts (M10) are reused,
check thread diameters of cylinder head
bolt (1) for deformation according to the
follows and replace them with new ones if
thread diameter difference exceeds limit.
• Measure each thread diameter of cylinder
head bolt (1) at "A" on 83.5 mm (2.81 in.)
from seat side of flange bolt and "B" on
115 mm (4.53 in.) from seat side of flange
bolt by using a micrometer (2).
Then calculate difference in diameters ("A"
– "B"). If it exceeds limit, replace with new
one.
Cylinder head bolt diameter measurement
points
"a": 83.5 mm (2.81 in.)
"b": 115 mm (4.53 in.)
Cylinder head bolt diameter difference
(deformation)
Limit ("A" – "B"): 0.1 mm (0.004 in.)
6) Install camshafts, tappet and shim referring to
"Camshaft, Tappet and Shim Removal and
Installation".
7) Install timing chain referring to "Timing Chain and
Chain Tensioner Removal and Installation".
8) Install timing chain cover referring to "Timing Chain
Cover Removal and Installation".
9) Install cylinder head cover referring to "Cylinder
Head Cover Removal and Installation".
10) Install oil pan referring to "Oil Pan and Oil Pump
Strainer Removal and Installation in Section 1E".
I5RW0C140030-01
Engine Mechanical:
1
"A"
"a"
"b"
1
2
1D-41
"B"
I2RH0B140092-01