4Wd Position Indicator Does Not Come On At Ignition Switch On But Engine Stops - Suzuki SX4 Service Manual

4WD Position Indicator Does Not Come ON at Ignition Switch ON but Engine Stops

Wiring Diagram
1
[A]: 4WD control module connector "G26" (viewed from harness side)
1. Main fuse box
2. Junction block assembly
3. "METER" fuse
Circuit Description
4WD position indicator operates according to the signal from 4WD control module. If the 4WD control system is in
good condition, 4WD position indicator light up for 2 seconds when ignition switch is turned to ON position, and then
turned to OFF position. If an abnormality is detected in the system, 4WD position indicator remains lighting.
Troubleshooting
Step
1 4WD position indicator power supply check
1) Turn ignition switch to ON position.
Do other indicators come ON?
2 Check DTC
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ignition switch to ON position and check DTC.
Is there DTC(s) U0073, U0100, U0121 and/or U0155?
2
WHT YEL
3
WHT/RED
4
5 6
BLK
RED
WHT
[A]
12 11 10
26 25 24 23 22 21
Action
G26-11
WHT/RED
RED/BLK G26-12
RED G26-22
WHT G26-23
BLK G26-10
9 8 7 5 4 3 2
6
20 19 18 17 16 15 14
Go to Step 2.
Go to applicable DTC
diag. flow.
Differential:
7
12V
1
13
4. Combination meter
5. 4WD AUTO indicator
6. 4WD LOCK indicator
7. 4WD control module
Yes
Go to Step 3.
Substitute a known-
good combination meter
and recheck. If 4WD
position indicator still
remains off, substitute a
known-good 4WD
control module and
recheck.
3B-16
S7RW0A3204012
I7RW01320004-01
No