Front And Rear Wheel Speed Sensor On-Vehicle Inspection - Suzuki SX4 Service Manual

Installation
1) Install hydraulic unit / control module assembly by
reversing removal procedure noting the following.
Install ABS hydraulic unit / control module assembly
bracket bolt as follows.
a) Tighten bracket bolt (1) and (2) by hand.
b) Then tighten bracket bolt to specified torque.
Tightening order (1) → (2)
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lb-ft)
ABS hydraulic unit / control module assembly
bolt (b): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
ABS hydraulic unit / control module assembly
bracket bolt (c): 26 N·m (2.6 kgf-m, 19.0 lb-ft)
2) Bleed air from brake system referring to "Air
Bleeding of Brake System in Section 4A".
3) Check each installed part for fluid leakage and
perform "ABS Hydraulic Unit Operation Check".
NOTE
For new ABS hydraulic unit / control module
assembly, if "ABS Hydraulic Unit Operation
Check" has not been performed, ABS
warning light may flash when ignition switch
is turned ON position.
Accordingly preform "ABS Hydraulic Unit
Operation Check" to stop flashing of ABS
warning light.
Front and Rear Wheel Speed Sensor On-Vehicle
Inspection
Output Voltage Inspection
1) Disconnect negative (–) cable from battery.
2) Hoist vehicle a little.
3) Disconnect wheel speed sensor connector.
4) Set up measuring device as shown in figure, the
resistance to 115 Ω and the power supply voltage to
12 V.
CAUTION
!
Incorrect voltage and/or wrong connection
cause damage to wheel speed sensor.
5
I6RW0C450011-01
1. Wheel speed sensor connector
2. Resistance (115Ω)
3. "WHT" wire terminal
ABS:
S7RW0A4506005
1
V
4
3
2
I5JB0A450026-03
4. "BLK" wire terminal
5. Power supply (12 V)
4E-34