Front Mounting Arm And/Or Rear Mounting Bracket Assembly Removal And Installation; Rear Mounting Bracket Assembly Disassembly And Reassembly; Rear Differential Dismounting And Remounting - Suzuki SX4 Service Manual

Hide thumbs

Advertisement

Table of Contents
Front Mounting Arm and/or Rear Mounting
Bracket Assembly Removal and Installation
Remove and install front mounting arm and/or rear
mounting bracket after rear differential removed.
For tightening torque of each bolt and nut, refer to "Rear
Differential Mountings Components".
Rear Mounting Bracket Assembly Disassembly
and Reassembly
Disassembly
Drive out mountings from rear mounting bracket using
special tool and hydraulic press.
Special tool
(A): 09913–70123
(B): 09951–26020
(A)
(B)
Reassembly
Press mountings in rear mounting bracket using special
tool and hydraulic press with caring its installation
position shown in figure.
Special tool
(A): 09913–85210
(B): 09951–26020
(A)
(B)

Rear Differential Dismounting and Remounting

Dismounting
S7RW0A3206010
1) Lift up vehicle and drain oil from rear differential.
2) Remove propeller shaft referring to "Propeller Shaft
Assembly Removal and Installation in Section 3D".
3) Remove rear drive shafts assembly referring to
"Rear Drive Shaft Assembly Removal and
Installation: Rear in Section 3A".
4) Support rear differential (3) with transmission jack
S7RW0A3206011
(4).
5) Remove mounting arm bolts (2) and rear mounting
bolts (1), and then lower rear differential with rear
mounting bracket.
Remounting
Reverse dismounting procedure for remounting of rear
I5RW0A320023-02
differential, noting the following points.
• Tighten each bolt to specified torque referring to "Rear
Differential Mountings Components".
• Fill gear oil to rear differential referring to "Rear
Differential Oil Change".
I5RW0A320024-02
1
2
Differential:
3B-34
S7RW0A3206012
3
4
I5RW0A320025-01

Advertisement

Table of Contents
loading

  Also See for Suzuki SX4

Table of Contents