6C-6 Power Assisted Steering System:
Step
8
Steering symptom diagnosis and P/S system
symptom diagnosis
1) Check and repair according to "Steering Symptom
Diagnosis in Section 6A" and "P/S System Symptom
Diagnosis".
Are check and repair complete?
9
Troubleshooting for DTC
1) Check and repair according to applicable DTC diag. flow.
Are check and repair complete?
10
Intermittent problems check
1) Check for intermittent problems referring to "Intermittent
Problems Check".
Is there any faulty condition?
11
Final confirmation test
1) Clear DTC if any.
2) Perform final confirmation test referring to "Final
Confirmation Test".
Is there any problem symptom, DTC or abnormal condition?
NOTE
• As execution of "DTC Clearance" will clear all DTCs, be sure to record all DTCs before service.
• DTC C1122 is indicated when ignition switch is at ON position and engine is not running, it means
that nothing is abnormal.
• Current DTC and history DTC can be identified by condition of the "EPS" warning light.
"EPS" warning light operates as follows.
Current DTC is set.
(Abnormality exists at
present.)
"EPS" warning light
after engine started
Action
Only history DTC is set.
(Faulty condition occurred once
in the past, but normal condition
is detected at present.)
Remains ON.
Yes
Go to Step 11.
Go to Step 11.
Repair or replace
malfunction part(s), and
go to Step 11.
Go to Step 6.
Current and history DTC
exist.
Turns OFF.
No
Check and repair
malfunction part(s), and
go to Step 11.
Check and repair
malfunction part(s), and
go to Step 11.
Go to Step 11.
End.
Remains ON.