Dtc Clearance; Fail-Safe Table - Suzuki SX4 Service Manual

DTC Clearance

WARNING
!
When performing a driving test, select a safe place where there is neither any traffic nor any traffic
accident possibility and be very careful during testing to avoid occurrence of an accident.
After repair or replace malfunction part(s), clear all DTCs by performing the following procedure or using SUZUKI scan
tool.
1) Connect SUZUKI scan tool to data link connector in the same manner as when making this connection for DTC
check.
2) Turn ignition switch to ON position.
3) Erase DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further
derails.
4) After completing the clearance, turn ignition switch OFF and disconnect scan tool from data link connector.
5) Perform "Driving Test" (Step 2 of "Electronic Stability Program Check") and "DTC Check" and confirm that NO DTC
is displayed on scan tool.

Fail-Safe Table

When any of the following DTC(s) is detected, ESP® system is in fail-safe mode per its DTC and ABS, EBD, TCS /
stability functions are deactivated until the resolution is applied.
Fail-safe operation
DTC No.
ABS
C1016 —
C1017
C1020 —
C1021 —
C1022 —
C1023
C1024
C1025 —
C1026 —
C1027
*3
C1028 —
C1031 —
C1032 —
C1033 —
C1034
C1035 —
C1036 —
C1037
TCS /
EBD
stability
—
— When ESP® control module detects the system as normal, after
— ignition switch turned OFF to ON.
*1 —
When ESP® control module detects the system as normal. And
*1 — estimated vehicle speed exceeds 14 km/h (9 mile/h), after ignition
switch turned OFF to ON.
—
When ESP® control module detects the system as normal, after
—
ignition switch turned OFF to ON.
*1 —
When ESP® control module detects the system as normal. And
*1 — estimated vehicle speed exceeds 14 km/h (9 mile/h), after ignition
switch turned OFF to ON.
When ESP® control module detects the system as normal, after
ignition switch turned OFF to ON. (ESP® OFF switch becomes
effective.)
— When ESP® control module detects the system as normal, after
*1 — ignition switch turned OFF to ON.
When ESP® control module detects the system as normal. And
*1 — estimated vehicle speed exceeds 14 km/h (9 mile/h), after ignition
switch turned OFF to ON.
*2 —
When ESP® control module detects the system as normal, after
—
ignition switch turned OFF to ON.
*1 —
When ESP® control module detects the system as normal. And
*1 — estimated vehicle speed exceeds 14 km/h (9 mile/h), after ignition
switch turned OFF to ON.
Electronic Stability Program:
Fail-safe condition resolutive
—
4F-19
S7RW0A4604007
S7RW0A4604008