Download Table of Contents Print this page

Blower Motor Controller Inspection; Hvac Control Module Removal And Installation; Sunload Sensor Removal And Installation - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
7B-82 Air Conditioning System: Automatic Type

Blower Motor Controller Inspection

1) Check internal circuit of controller for resistance as
follows.
a) Measure resistance between "1" terminal and "2"
terminal of blower motor controller.
Blower motor controller resistance
"1" – "2": approximately 10 kΩ
If resistance does not meet above specification,
replace blower motor controller.
b) Using ohmmeter, connect its positive terminal to
"3" terminal of blower motor controller and
negative terminal to "1" terminal of blower motor
controller and check that there is no continuity.
2) Check controller for operation as follows.
a) Using bulb (3.4 W) (5) and service wire, connect
battery positive terminal to "3" terminal of blower
motor controller as shown in figure.
b) Using service wire, connect battery negative
terminal to "1" terminal of blower motor
controller.
c) Arrange 3 new 1.5 V batteries (6) in series
(check that total voltage is 4.5 – 5.0 V) and
connect its positive terminal to "2" terminal of
blower motor controller and negative terminal to
"1" terminal of blower motor controller.
Then, check that bulb lights. If bulb does not light
under the above conditions, replace blower
motor controller.
2
4
4
2
S7RW0A7226012
1
3
3
5
1
6
I7RW01722027-01

HVAC Control Module Removal and Installation

Removal
1) Remove audio unit from instrument panel referring to
"Audio Unit Removal and Installation (If Equipped) in
Section 9C".
2) Remove HVAC control module (1) with its garnish (2)
from instrument panel.
3) Remove HVAC control module from garnish.
1
2
Installation
Reverse removal procedure.

Sunload Sensor Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove combination meter from instrument panel
referring to "Combination Meter Removal and
Installation in Section 9C".
3) Remove sunload sensor (1) from instrument panel
by depressing tab and pushing sensor upward from
underneath.
4) Disconnect sunload sensor connector (2).
S7RW0A7226013
I5RW0A722024-02
S7RW0A7226014
1
2
I7RW01722028-01

Advertisement

Table of Contents
loading

Table of Contents