Download Table of Contents Print this page

Suzuki SX4 Service Manual page 900

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
5B-34 Manual Transmission/Transaxle:
9) Install circlip (1) and confirm that circlip is installed in
groove securely.
Install needle bearing (2) and apply oil to needle
bearing.
With synchronizer outer ring (3), center cone (4) and
inner ring (5) put together and installed to 2nd gear
(6) as shown in figure.
[A]: Section A – A
10) Press-fit 3rd gear (2) and spacer (1) by using special
tools and hydraulic press.
NOTE
It is recommended to press-fit spacer and 3rd
gear first, and then 4th gear later separately
so that countershaft will not be compressed
excessively.
Special tool
(A): 09923–78210
(B): 09913–85210
3. 2nd gear
11) Press-fit 4th gear (2) by using the same procedure at
step 10).
12) Install left bearing cone (1) by using special tool and
hydraulic press.
NOTE
For protection of bearing cone (3), always
support shaft with special tool as shown in
figure.
Special tool
(A): 09923–78210
(E): 09913–80113
I5RW0A520040-01
I4RH01520036-01
I2RH01520066-01

Advertisement

Table of Contents
loading

Table of Contents