3B-31 Differential:
2WD/4WD Switch Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove console box (2).
3) Remove 2WD/4WD switch (1) from console box.
1
Installation
Reverse removal procedure for installation.
2WD/4WD Switch Inspection
Check 2WD/4WD switch for continuity between
terminals at each switch position.
If check result is not as specified, replace switch.
5
4
3
Terminal
1
Switch position
2WD
AUTO
LOCK
S7RW0A3206003
2
I5RW0A320017-02
S7RW0A3206004
1
2
3
2
4
5
I5RW0A320018-02
4WD Control Module Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove center ventilation louver referring to "Center
Ventilation Louver Removal and Installation in
Section 7A".
3) Disconnect connector (1) from 4WD control module.
4) Remove 4WD control module (2).
Installation
Reverse removal procedure for installation.
Coupling Air Temperature Sensor Removal and
Installation
Removal
1) Dismount rear differential referring to "Rear
Differential Dismounting and Remounting".
2) Remove coupling air temperature sensor (1) from
rear differential (2).
1
Installation
Reverse removal procedure for installation, noting the
following point.
• Tighten coupling air temperature sensor to specified
torque.
Tightening torque
Coupling air temperature sensor: 18 N·m (1.8 kgf-
m, 13.0 lb-ft)
S7RW0A3206005
2
1
I5RW0A320019-01
S7RW0A3206006
2
I5RW0A320020-02