Suzuki SX4 Service Manual page 949

Step
3 Communication check
1) Check DLC terminal for deformation and wear.
2) If it is in good condition, connect SUZUKI scan tool to
DLC with ignition switch tuned OFF.
3) Check if communication is possible by making
communication with other control modules (BCM, ABS,
HVAC control module or SDM).
Is it possible to communicate with the other control
modules?
4 Serial communication circuit check
1) With ignition switch turned OFF, disconnect "E11"
connector from P/S control module and check for proper
connection at P/S control module connector terminal.
2) If connections are OK, check that "Serial data circuit" is
as follows.
• Wiring resistance of "Serial data circuit" wire between
DLC connector and P/S control module connector is
less than 1 Ω.
Is it resistance less than 1
5 P/S control module power and ground circuit check
1) Check power supply circuit and ground circuit for P/S
control module referring to "P/S Control Module Power
Supply and Ground Circuit Check".
Is check result in good condition?
6 DLC power and ground circuit check
1) Check power supply circuit and ground circuit for DLC
connector as follows.
• Voltage of "DLC connector power supply circuit"
between DLC connector terminal and vehicle body
ground is 10 –14 V with ignition switch turned ON.
• Wire resistance of each "DLC connector ground
circuit" between DLC connector terminal and vehicle
body ground is less than 1 Ω.
Is check result in good condition?
7 Serial communication circuit check
1) With ignition switch turned OFF, disconnect "E11"
connector from P/S control module and check for
terminal to P/S control module connector.
2) If connections are OK, check that "Serial data circuit" is
as follows.
• Insulation resistance of "Serial data circuit" wire is
infinity between its terminal and other terminals at P/S
control module connector.
• Insulation resistance of "Serial data circuit" wire is
infinity between its terminal and vehicle body ground.
Is circuit in good condition?
Action
Ω
?
Power Assisted Steering System:
Yes
Go to Step 4.
Go to Step 5.
Substitute a known-
good P/S control
module and recheck.
Go to Step 7.
Go to Step 8.
6C-15
No
Go to Step 6.
"Serial data circuit" is
open or high resistance.
Repair or replace
defective circuit.
Repair or replace
defective circuit.
Repair or replace
defective circuit.