Dtc B1062 / B1066: Side-Air Bag Circuit Low Resistance - Suzuki SX4 Service Manual

DTC B1062 / B1066: Side-Air Bag Circuit Low Resistance

DTC B1062: Driver Side-Air Bag Circuit Low Resistance
DTC B1066: Passenger Side-Air Bag Circuit Low Resistance
Wiring Diagram
Refer to "DTC B1061 / B1065: Side-Air Bag Circuit High Resistance".
DTC Detecting Condition and Trouble Area
DTC detecting condition
DTC B1062:
Driver side-air bag circuit is less than 1.0 Ω for more than
4 sec.
DTC B1066:
Passenger side-air bag circuit is less than 1.0 Ω for more
than 4 sec.
DTC Troubleshooting
Step
1 Was "Air Bag Diagnostic System Check Flow" performed?
2 Side-air bag circuit check
1) Remove applicable driver / passenger side-air bag
(inflator) module from seat back referring to "Side-Air
Bag (Inflator) Module Removal and Installation".
2) Check for proper connection to applicable side-air bag
(inflator) module at terminal in connector "Q104" or
"Q105".
3) If OK, then connect special tools (A), (B) and (C) to
applicable side-air bag (inflator) connector "Q104" or
"Q105".
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78310
4) Check SDM for DTC.
With ignition switch turned ON, is DTC B1062 or B1066 still
indicated?
Action
"Q104", "Q105"
(A)
STEERING WHEEL
• Driver / passenger side-air bag circuit
• Driver / passenger side-air bag module
• SDM
Yes
Go to Step 2.
Go to Step 3.
(C)
(B)
I7RW01822077-01
Air Bag System:
S7RW0A8204031
Trouble area
No
Go to "Air Bag
Diagnostic System
Check Flow".
Replace side-air bag
(inflator) module
referring to "Side-Air
Bag (Inflator) Module
Removal and
Installation".
8B-58