Download Table of Contents Print this page

And Installation; Gear Select Control Cable Adjustment - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
Gear Shift Control Lever and Cable Removal

and Installation

Removal
1) Remove console box.
2) Disconnect cable ends (5) from pivot (6) of gear shift
control lever assembly by removing clip.
3) Disconnect gear shift and select control cables (1)
from gear shift control lever assembly (2) while
pulling quick joint (4) as shown in figure.
4) Remove gear shift control lever assembly mounting
nuts (3) and gear shift lever assembly from floor
panel.
5) Disconnect gear shift and select control cables from
transaxle.
6) Remove cable grommet bolt, and then remove gear
shift and select control cables from floor panel.
3
4
1
Installation
Reverse removal procedure for installation nothing the
following.
• Tighten each bolts and nuts to specified torque
referring to "Gear Shift Control Lever and Cable
Components".
• Adjust gear select control cable referring to "Gear
Select Control Cable Adjustment".
S7RW0A5206005
2
3
6
5
I4RS0A520003-01
Manual Transmission/Transaxle:

Gear Select Control Cable Adjustment

1) Release lock plate (1) which restricts moving of
cable end holder (2).
2) Push cable end holder (2) out from adjuster (4) using
appropriate tool (3) to disengage cable.
5B-9
S7RW0A5206006
I4RS0A520004-01

Advertisement

Table of Contents
loading

Table of Contents