Transmission Range Sensor Check; Output Shaft Speed Sensor Check - Suzuki Baleno Manual

1. PCM coupler disconnected

TRANSMISSION RANGE SENSOR CHECK

Check transmission range sensor referring to Step 2 of DTC P0705
Flow Table.

OUTPUT SHAFT SPEED SENSOR CHECK

1) Turn OFF ignition switch.
2) Disconnect coupler(s) from powertrain control module.
3) Bring ohmmeter probes in touch with coupler terminals from
harness side.
4) Check resistance of output shaft speed sensor.
Resistance between terminals
C20-10 and C20-11
(For vehicle with WU-TWC)
C21-3 and C21-14
(For vehicle without WU-TWC)
Resistance between terminal
and ground
If resistance are out of specification, check wire harness and
connector for open or short and output shaft speed sensor itself
for resistance.
If resistance are within above specifications, proceed to next
step.
5) Visually check output shaft speed sensor and counter shaft
gear for the following:
D No damage
D No foreign material attached
D Correct installation
If any malfunction is found, clean, repair or replace.
AUTOMATIC TRANSMISSION (3 A/T) 7B-43
: 100 – 300 W
: 1 MW or more