Front And Rear Wheel Speed Sensor Inspection; Rear Wheel Speed Sensor Removal And Installation (4Wd Model); Rear Wheel Speed Sensor Removal And Installation (2Wd Model) - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:
Table of Contents

Advertisement

Installation
1) Check that no foreign material is attached to sensor
(1) and wheel speed sensor encoder (included in
wheel hub assembly).
2) Install it by reversing removal procedure.
NOTE
Before fitting wheel speed sensor, be sure to
silicon grease to its O-ring.
Tightening torque
Front wheel speed sensor bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Front wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
(b)
(a)
1
3) Check that there is no clearance between sensor
and knuckle.
[A]
1
[A]: OK

Front and Rear Wheel Speed Sensor Inspection

Check sensor for damage.
If any malcondition is found, replace.
2
I5RW0A450025-01
[B]
1
I5RW0A450024-01
[B]: NG
S7RW0A4506007
I5JB0A450031-01
Rear Wheel Speed Sensor Removal and
Installation (4WD Model)
CAUTION
!
Rear wheel speed sensor is included in rear
wheel hub assembly. If rear wheel speed
sensor needs to be replaced, replace it as a
rear wheel hub assembly.
For removal and Installation of rear wheel speed sensor
(included in rear wheel hub), refer to "Rear Wheel Hub
Assembly Removal and Installation in Section 2C".
Rear Wheel Speed Sensor Removal and
Installation (2WD Model)
CAUTION
!
• Do not pull wire harness when removing
and installing rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
Removal
1) Disconnect negative (–) cable from battery.
2) Hoist vehicle, and remove wheel.
3) Disconnect rear wheel speed sensor connector.
4) Remove harness clamp.
5) Remove rear wheel speed sensor from wheel hub.
Installation
1) Check that no foreign material is attached to sensor
and encoder (included in wheel hub assembly).
2) Install it by reversing removal procedure.
NOTE
Before fitting wheel speed sensor, be sure to
silicon grease to its O-ring.
Tightening torque
Rear wheel speed sensor bolt: 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
3) Check that there is no clearance between sensor
and wheel hub.
[A]
1
[A]: OK
ABS:
4E-36
S7RW0A4506008
S7RW0A4506009
[B]
1
I5RW0A450024-01
[B]: NG

Advertisement

Table of Contents
loading

Table of Contents

Save PDF