Download Table of Contents Print this page

Back Up Light Switch Removal And Installation; Back Up Light Switch Inspection - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
5B-10 Manual Transmission/Transaxle:
3) Apply grease to pin (5) of gear shift control lever, and
then install adjuster (1) into pin of gear shift control
lever securely.
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
4) Push cable end holder (2) in the direction of A.
NOTE
At this time, do not apply force in the cable
operation direction B to adjuster.
5) Slide lock plate (3) in the direction of C, until it gets
over the claw (4) of cable end holder.
3
4
C
3
A
1
B
5,
"A"
1
2
I4RS0A520005-01

Back Up Light Switch Removal and Installation

Removal
1) Remove battery and tray with ECM.
2) Disconnect back up light switch coupler (1).
3) Remove back up light switch.
2. Gear shift and select shaft assembly
Installation
1) Apply oil to new O-ring (1) and tighten back up light
switch (2) to specified torque.
Tightening torque
Back up light switch (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
1
2) Connect back up light switch coupler.
3) Install battery and tray with ECM.

Back Up Light Switch Inspection

Check back up light switch for function using ohmmeter.
Switch ON (Push): Continuity
Switch OFF (Release): No continuity
S7RW0A5206007
2
1
I5RW0A520009-01
2, (a)
I3RH0A520006-01
S7RW0A5206008
I5RW0A520050-01

Advertisement

Table of Contents
loading

Table of Contents