Suzuki SX4 Service Manual page 442

2B-11 Front Suspension:
6) Using special tool and hydraulic press, press fit
wheel hub (1) into wheel bearing (2) (Face grooved
rubber seal side to wheel hub).
Special tool
(A): 09913–75510
7) Apply grease lightly to end face of inner ring (1).
"A": Grease 99000–25121 (SUZUKI Super
Grease H)
NOTE
Do not apply the grease to the encoder
section to avoid the encoder malfunction.
8) Install steering knuckle with wheel hub and bearing
(1) so that foreign material should not enter wheel
speed sensing point "a".
2. Wheel encoder
3. Drive shaft
9) Install ball joint bolt (1), washer (2), strut bracket
bolts (4) and new nuts (3) from the direction shown
in figure.
10) Tighten suspension arm ball joint bolt (2) to specified
torque.
Tightening torque
Suspension arm ball joint bolt (a): 60 N·m (6.0
kgf-m, 43.5 lb-ft)
11) Tighten new strut bracket nuts (3) to specified
torque.
Tightening torque
Strut bracket nut (b): 140 N·m (14.0 kgf-m, 101.5
lb-ft)
I7RW01220007-01
12) Install wheel speed sensor (1).
Tightening torque
Wheel speed sensor mounting bolt (a): 11 N·m (
1.1 kgf-m, 8.0 lb-ft)
I5RW0B220001-01
I7RW01220008-02
4
F
F: Vehicle front
3, (b)
2
1, (a)
I7RW01220009-01
(a)
1
I5RW0A220017-01