Installation
Reverse removal procedure noting the following
instructions.
• Install sunload sensor (1) to instrument panel fitting
tab (2) of sunload sensor into the groove (3) of
instrument panel as shown in figure.
3
F
F: Vehicle forward
Sunload Sensor Inspection
1) Light over sunload sensor vertically with an
incandescent light of approximately 100 W. The
distance between sunload sensor and light should
be approximately 100 mm (3.94 in.).
2) Measure voltage between terminals "a" and "b" of
sunload sensor as shown in figure.
If check result is not satisfactory, replace sunload
sensor with new one.
Sunload sensor voltage specification
"a" – "b": Approx. 0.38 – 0.42 V
Outside Air Temperature Sensor Removal and
Installation
Refer to "Outside Air Temperature Sensor Removal and
Installation (If Equipped) in Section 9C".
Outside Air Temperature Sensor Inspection
Refer to "Outside Air Temperature Sensor Inspection (If
Equipped) in Section 9C".
Inside Air Temperature Sensor Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove audio unit from instrument panel referring to
2
3) Remove combination meter from instrument panel
1
4) Remove connector (3) and aspirator hose (1) from
5) Remove inside air temperature sensor (2) from
I7RW01722029-01
S7RW0A7226015
Installation
Reverse removal procedure.
Inside Air Temperature Sensor Inspection
Measure resistance between each connector terminal
with an ohmmeter.
If resistance is incorrect, replace inside air temperature
"b"
"a"
sensor with new one.
I5JB0A720053-01
Inside air temperature sensor resistance
2.2 ± 0.07 kΩ at 25 °C (77 °F)
S7RW0A7226016
S7RW0A7226017
Air Conditioning System: Automatic Type 7B-83
"Audio Unit Removal and Installation (If Equipped) in
Section 9C".
referring to "Combination Meter Removal and
Installation in Section 9C".
inside air temperature sensor (2).
instrument panel by removing screw (4).
S7RW0A7226018
1
4
3
2
I7RW01722031-01
S7RW0A7226019
I7RW01722030-01