Download Table of Contents Print this page

Ignition Switch Cylinder Assembly Removal And Installation (Non- Keyless Start Model); Steering Lock Assembly (Ignition Switch) Removal And Installation - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:

Advertisement

Table of Contents
6B-9 Steering Wheel and Column:
Ignition Switch Cylinder Assembly Removal
and Installation (Non- Keyless Start Model)
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
3) Remove steering column upper and lower covers.
4) (Immobilizer model)
Remove immobilizer control module referring to
"ICM Removal and Installation in Section 10C".
5) Remove ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) Insert 2 mm (0.078 in.) rod (2) through hole (3)
and push ignition switch cylinder lock.
c) Detach ignition switch cylinder assembly (1) from
steering lock assembly (4).
Installation
1) Install ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) In this state, push ignition switch cylinder
assembly into steering lock assembly till it clicks.
2) (Immobilizer model)
Install immobilizer control module referring to "ICM
Removal and Installation in Section 10C".
3) Install upper and lower cover and screws.
4) Connect negative (–) cable to battery.
5) Enabling air bag system referring to "Enabling Air
Bag System in Section 8B".
6) (Immobilizer model)
If ignition switch cylinder assembly (that is ignition
key) has replaced, register ignition key transponder
code to ECM referring to "Registration of the Ignition
Key in Section 10C".
S7RW0A6206008
2
3
1
4
I5JB0A620025-01
Steering Lock Assembly (Ignition Switch)
Removal and Installation
Removal
1) Remove steering column. Refer to "Steering Column
Removal and Installation".
2) Using center punch (1), loosen and remove steering
lock mounting bolts (2).
NOTE
Use care not to damage aluminum part of
steering lock body with center punch.
3) Turn ignition key to "ACC" or "ON" position and
remove steering lock assembly from steering
column.
Installation
1) Position oblong hole (1) of steering shaft (2) in the
center of hole (3) in column (4).
2) Turn ignition key to "ACC" or "ON" position and
install steering lock assembly (5) onto column (4).
3) Now turn ignition key to "LOCK" position and pull it
out.
4) Align hub on lock with oblong hole (1) of steering
shaft (2) and rotate shaft to assure that steering shaft
is locked.
1
3
S7RW0A6206009
I4RS0B620005-02
2
4
I4RS0B620006-02
5

Advertisement

Table of Contents
loading

Related Content for Suzuki SX4

Table of Contents