Transmission Range Sensor (Shift Switch) Inspection And Adjustment - Suzuki Swift Sport 2004 Service & Repair Manual

5) Shift select lever to "N" position.
NOTE
If select lever is in "P" position, shift select
lever referring to "Select Lever Inspection".
6) Install cable casing cap (3) to selector bracket (4).
7) Connect cable end (1) to interlock cam (2) with
ignition switch turned to ACC position.
8) Drive lock button (5) in cable end until it locks cable
expansion and contraction.
5
3
3
4
9) With select lever set at "P" position, turn ignition key
to ACC position and then check for the following
conditions.
• With knob button released, ignition key can be
turned from ACC position to LOCK position.
• With knob button pressed, ignition key cannot be
turned from ACC position to LOCK position.
10) Install steering column cover.
11) If the vehicle is equipped with air bag system,
connect negative cable at battery and enable air bag
system, referring to "Enabling Air Bag System in
Section 8B".
Transmission Range Sensor (Shift Switch)
Inspection and Adjustment
1) Shift manual select lever (4) to "N" range.
2) Check that needle direction shaped on lock washer
(2) and "N" reference line (1) on transmission range
sensor are aligned. If not, loosen sensor bolts (3)
and align them.
Tightening torque
Transmission range sensor bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
2
1
I4RS0A510055-01
3) Check that engine starts in "N" and "P" ranges but it
doesn't start in "D", "2", "L" or "R" range. Also, check
that back-up lamp lights in "R" range.
If faulty condition cannot be corrected by adjustment,
disconnect transmission range sensor connector
and check that continuity exists as shown by moving
manual select lever.
Automatic Transmission/Transaxle:
3 2
4
9 8 6
7
1 2 3 4 5
P
R
N
D
2
L
5A-95
S7RS0B5106015
I3RM0B510038-01
1
5
8 9
6 7
I3RM0B510039-01