1D-20 Engine Mechanical:
6) Install engine right mounting bracket (1) and engine
left mounting bush bolt (2), and then tighten bolt and
nuts to specified torque.
Tightening torque
Engine right mounting bracket nut (a): 65 N·m (
6.5 kgf-m, 47.0 lb-ft)
Engine right mounting bush bolt (b): 55 N·m (5.5
kgf-m, 40.0 lb-ft)
Engine left mounting bush bolt (c): 85 N·m (8.5
kgf-m, 61.5 lb-ft)
1
7) Install suspension frame mounting bolts (1) and front
lower cross member bolts (2). And then tighten bolts
to specified torque.
Tightening torque
Suspension frame mounting bolt (a): 150 N·m (
15.0 kgf-m, 108.5 lb-ft)
Front lower cross member bolt (b): 55 N·m (5.5
kgf-m, 40.0 lb-ft)
(a)
(b)
2,(c)
I5RW0C140031-01
2,(b)
1,(a)
I5RW0A140016-01
8) Connect steering lower shaft from pinion shaft
referring to "Steering Lower Shaft Removal and
Installation in Section 6B".
9) Connect propeller shaft referring to "Propeller Shaft
Assembly Removal and Installation in Section 3D"
(for 4WD model)
10) Install exhaust No.1, No.2 and center pipes referring
to "Exhaust System Components in Section 1K".
11) Reverse disconnected hoses, cables and electric
wires for connection noting the following.
• Tighten bolts and nuts to specified torque.
Tightening torque
Starting motor terminal nut (a): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
Generator terminal nut (b): 5 N·m (0.5 kgf-m, 4.0
lb-ft)
Battery ground bolt (c): 25 N·m (2.5 kgf-m, 18.0
lb-ft)
Ground terminal bolt (d): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
(a)
(d)
[A]
[B]
[A]: For M/T model
(b)
(c)
(c)
I5RW0C140013-02
[B]: For A/T model