1A-26 Engine General Information and Diagnosis:
1) Prepare CAN communication OBD generic scan tool
or SUZUKI scan tool.
Special tool
(A): SUZUKI scan tool (SUZUKI-SDT)
2) With ignition switch OFF, connect it to DLC (1)
located on underside of instrument panel at driver's
seat side.
1
(A)
3) Turn ignition switch ON and confirm that MIL lights.
4) Read DTC and freeze frame data according to
instructions displayed on scan tool and print them or
write them down. Refer to scan tool operator's
manual for details.
If communication between scan tool and ECM is not
possible, go to "Troubleshooting for Communication
Error with Scan Tool Using CAN".
5) After completing the check, turn ignition switch off
and disconnect scan tool from DLC.
DTC Clearance
NOTE
There are two types of OBD system
depending on the vehicle specification.
For identification, refer to "Precaution on On-
Board Diagnostic (OBD) System".
1) Connect SUZUKI scan tool or CAN communication
OBD generic scan tool to data link connector in the
same manner as when making this connection for
DTC check.
2) Turn ignition switch OFF and then ON.
3) Erase DTC and pending DTC according to
instructions displayed on scan tool. Freeze frame
data is cleared with the DTC. Refer to scan tool
operator's manual for further details.
If communication between scan tool and ECM is not
possible, go to "Troubleshooting for Communication
Error with Scan Tool Using CAN".
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector.
NOTE
DTC and freeze frame data stored in ECM
memory are also cleared in the following
cases. Be careful not to clear them before
keeping their record.
• When power to ECM is cut off (by
disconnecting battery cable, removing
fuse or disconnecting ECM connectors).
• When the same malfunction (DTC) is not
detected again during 40 engine warm-up
cycles. (See "Warm-Up Cycle" of "On-
Board Diagnostic System Description".)
Troubleshooting for Communication Error with
Scan Tool Using CAN
Perform this troubleshooting when it is not possible to
communicate between scan tool and ECM/TCM.
I5RW0C110011-01
NOTE
• When performing this troubleshooting, be
sure to have full understanding of
"Precaution on CAN Troubleshooting" and
observe it.
• It may be possible that CAN system has
trouble because of fuse blown or low
battery voltage. Before troubleshooting,
check to make sure that fuse, battery
voltage and generator status are normal.
• When disconnecting each control module
connector in this troubleshooting, various
DTCs will be detected. Be sure to clear
S7RW0A1104004
DTCs in the following control modules
after completing this troubleshooting.
– ECM
– BCM
– TCM
– Keyless start control module
– ESP® control module
– 4WD control module
– HVAC control module (Auto A/C model)
– P/S control module
S7RW0A1104005