48) Install transaxle rear cover assembly on transaxle
case.
49) Install hook (2) to location shown in figure.
50) Tighten rear cover bolts (1).
Tightening torque
Rear cover bolt (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
51) Install fluid reservoir LH plate (1).
Tightening torque
Fluid reservoir LH plate bolt (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
52) After applying A/T fluid to new governor apply No.2
gasket (1), install it to transaxle case.
53) After applying A/T fluid to differential assembly (1)
and countershaft assembly (2), install them to
transaxle case.
54) After applying A/T fluid to direct clutch hub (1), install
it to planetary gear assembly.
I3RM0B510068-01
55) After applying A/T fluid to input shaft rear thrust
bearing (1) and thrust bearing race (2), install them
into direct clutch hub (3).
I2RH0B510303-01
56) After applying A/T fluid to input shaft front thrust
bearing (1), install it to direct clutch assembly (2).
I2RH0B510304-01
Automatic Transmission/Transaxle:
1
2
5A-155
I4RS0A510036-01
I2RH0B510306-01
I2RH0B510307-01
I2RH0B510308-01
Need help?
Do you have a question about the SX4 and is the answer not in the manual?
Questions and answers