Enabling Air Bag System; Sdm Removal And Installation - Suzuki SX4 Service Manual

8B-95 Air Bag System:

Enabling Air Bag System

1) Confirm that battery negative (–) cable is
disconnected.
2) Turn ignition switch to "LOCK" position and remove
key.
3) Connect yellow connector (1) of driver air bag
(inflator) module by pushing connector till click is
heard from it.
4) Connect yellow connector (1) of passenger air bag
(inflator) module by pushing connector till click is
heard from it.
1
5) Install driver and passenger side front pillar lower
trim.
6) Connect yellow connector (1) of side-air bag
(inflator) module by pushing connector till click is
heard from it.
7) Connect connector of side curtain-air bag (inflator)
S7RW0A8206002 module and then install each trim as follows.
For hatchback model:
a) Connect yellow connector (1) by pushing
b) Install right-side rear quarter lower trim.
1
For sedan model
a) Connect black connector (1).
I5RW0A820091-01
b) Lock connector with lock button (2).
c) Install rear pillar inner trim.
d) Install rear seat side back referring to "Rear Seat
e) Install rear side sill scuff.
a)
I5RW0A820062-02
8) Install "A/B" fuse to fuse box.
9) Connect negative (–) cable at battery.
10) Turn ignition switch to ON position and verify that
"AIR BAG" warning light flashes 6 times and then
turns OFF. If it does not operate as described,
perform "Air Bag Diagnostic System Check".

SDM Removal and Installation

WARNING
!
During service procedures, be very careful
1
when handling a Sensing and Diagnostic
I5JB0A820070-01
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System" before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
connector till click is heard from it.
1
Components in Section 9G".
2
b)
1
I5RW0A820063-01
I6RW0B820020-01
S7RW0A8206003