Water Pump / Generator Drive Belt Removal And Installation; Generator Dismounting And Remounting - Suzuki SX4 Service Manual

Hide thumbs

Advertisement

Table of Contents
1J-8 Charging System:
Water Pump / Generator Drive Belt Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) If vehicle equipped with A/C, remove compressor
drive belt before removing water pump belt (1).
Refer to "Compressor Drive Belt Removal and
Installation: Manual Type in Section 7B" or
"Compressor Drive Belt Removal and Installation:
Automatic Type in Section 7B".
3) Loosen generator bracket bolts (2) and generator
pivot bolt (3).
4) Loosen generator adjusting bolt (4), and then
remove water pump belt.
4
2

Generator Dismounting and Remounting

1) Disconnect negative cable at battery.
2) Remove right side drive shaft referring to "Front Drive Shaft Assembly Removal and Installation: Front in Section
3A"
3) Dismount in numerical order as shown in figure.
4) Reverse dismounting procedure for remounting.
1. "B" terminal nut
2. "B" terminal wire
3. Connector
4. Generator bracket bolt
S7RW0A1A06004
1
3
I5RW0C160008-01
5. Generator pivot bolt
6. Generator drive belt
7. Generator
: 5.0 N⋅m (0.5 kg⋅m, 4.0 lb-ft)
installation
1) Install belt (1) to water pump pulley (2), crankshaft
pulley (3) and generator pulley (4).
2) Adjust belt tension referring to "Water Pump /
Generator Drive Belt Tension Inspection and
Adjustment".
3) If vehicle equipped with A/C, install compressor drive
belt referring to "Compressor Drive Belt Removal
and Installation: Manual Type in Section 7B" or
"Compressor Drive Belt Removal and Installation:
Automatic Type in Section 7B".
4
4) Connect negative cable at battery.
: 25 N⋅m (2.5 kgf-m, 18.0 lb-ft)
: 50 N⋅m (5.0 kgf-m, 36.0 lb-ft)
2
1
3
I5RW0C160009-01
S7RW0A1A06005
I6RW0D1A0004-01

Advertisement

Table of Contents
loading

  Also See for Suzuki SX4

Table of Contents