Dtc Clearance - Suzuki Grand Vitara Manual

3) Read DTC according to instructions displayed on
SUZUKI scan tool and write it down. Refer to
SUZUKI scan tool operator's manual for further
details.
4) After completing the check, turn ignition switch OFF
and disconnect SUZUKI scan tool from data link
connector (DLC).
Reading DTC Using Monitor Connector (If Equipped)
1) Turn ignition switch OFF.
2) Remove steering column hole cover (1).
3) Using service wire, connect diagnosis switch
terminal (3) of monitor connector (2) to body ground.
1
3
4) With ignition switch ON position and leaving engine
OFF, read DTC displayed on digital display odometer
(1) referring to "DTC Table: ".
1
5) After completing the check, turn ignition switch OFF
and disconnect service wire from monitor connector.
www.CarGarage.ir
2
I5JB0A510017-01
I5JB0A510018-01
www.CarGarage.ir
Automatic Transmission/Transaxle:

DTC Clearance

Automatic transmission DTC can be cleared using any
one of the following 2 methods.
NOTE
DTC and freeze frame data stored in TCM
memory are also cleared in following cases.
Be careful not to clear them before keeping
their record.
• When power to TCM is cut off (by
disconnecting battery cable, removing
fuse or disconnecting TCM connector).
• When the same malfunction (DTC) is not
detected again during 40 engine warm-up
cycles.
DTC Clearance Using SUZUKI Scan Tool
1) Turn ignition switch OFF.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1).
Special tool
(A): SUZUKI scan tool
(A)
3) Clear DTC according to instructions displayed on
SUZUKI scan tool. Refer to SUZUKI scan tool
operator's manual for further details.
4) After completing the clearance, turn ignition switch
OFF and disconnected SUZUKI scan tool from data
link connector (DLC).
5A-23
S5JB0A5104007
1
I5JB0A510016-01