Suzuki SX4 Service Manual page 272

Hide thumbs Also See for SX4:
Table of Contents

Advertisement

1C-3 Engine Electrical Devices:
4) Take off finger from opened throttle valve (1) which is
at full open position and check that it moves
smoothly by its return spring and open spring force
back to default position (position where throttle valve
is open by 7° (2) from completely closed position).
5) Move throttle valve with finger to its completely
closed position and check that it moves smoothly.
6) Take off finger from closed throttle valve (1) which is
at completely closed position and check that it
moves smoothly by its return spring and open spring
force back to default position.
2
If check result is not satisfactory, replace electric
throttle body assembly.
Electric Throttle Body Assembly Operation Check
1) Remove air cleaner outlet hose.
2) Turn ON ignition switch.
3) Depress accelerator pedal gradually and check that
throttle valve moves smoothly until it opens fully.
4) Release accelerator pedal depressed in Step 3) and
check that throttle valve (1) moves back to default
position (position where throttle valve is open by 7°
(2) from its completely closed position).
2
If check result is satisfactory, electric throttle body
system is in good condition.If check result is not
satisfactory, proceed to next step.
5) Perform "Accelerator Pedal Position (APP) Sensor
Assembly On-Vehicle Inspection", "Throttle Actuator
(Motor) Check" and "Throttle Position Sensor
Performance Check".
If check results are not satisfactory, replace electric
throttle body assembly.
If check results are satisfactory, wire circuit and/or
ECM are faulty.
1
I4RS0B130005-01
1
I4RS0B130005-01
Throttle Actuator (Motor) Check
1) Turn OFF ignition switch.
2) Disconnect connector from electric throttle body
assembly.
3) Measure resistance between "M1" terminal (1) and
"M2" terminal (2) of electric throttle body assembly.
If measured resistance is out of specified value,
replace electric throttle body assembly.
Throttle actuator (motor) resistance
0.3 – 100 Ω at 20 °C (68 °F)
Throttle Position Sensor Performance Check
1) Remove air cleaner outlet hose.
2) Turn OFF ignition switch.
3) Disconnect connector from electric throttle body
assembly.
4) Check throttle position sensor (main and sub) output
voltage as following steps.
a) For throttle position sensor (main), arrange 3
new 1.5 V batteries (1) in series (check that total
voltage is 4.5 – 5.0 V) and connect its positive
terminal to "Vin" terminal (2) and negative
terminal to "Ground" terminal (3) of sensor. Then
using voltmeter, connect positive terminal to
"Vout 1" terminal (4) of sensor and negative
terminal to battery.
4
1
2
I4RS0B130023-01
2
3
1
I4RS0B130007-02

Advertisement

Table of Contents
loading

Table of Contents

Save PDF