Dtc Clearance - Suzuki Ignis Service Manual

1
(C)
3
2
Condition between diagnosis switch
terminal and ground terminal
"b"
Open
Ground
"a"

DTC CLEARANCE

USING SUZUKI SCAN TOOL
1) Turn ignition switch to OFF position.
2) After setting cartridge connect SUZUKI scan tool, connect
scan tool to data link connector (DLC) (1) located on under-
side of instrument panel at driver's seat side.
Special tool
(A) : 09931-76011
(B) : Master storage cartridge
(C) : 09931-76030
3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on SUZUKI
scan tool referring to "SUZUKI SCAN TOOL OPERATOR'S
MANUAL" for further details.
5) After completing the check, turn ignition switch to OFF posi-
tion and disconnect SUZUKI scan tool from DLC.
(A)
(B)
NOT USING SUZUKI SCAN TOOL
1) Remove glove box.
2) Turn ignition switch to ON position.
3) Using jumper wire, short diagnosis switch terminal (1) to
ground terminal (2) of monitor coupler (3).
4) Make the disconnected end of jumper wire (4) contact where
disconnected (short) and repeat these actions (open and
short) at least 5 times within 10 seconds.
DTC clearance procedure specification
"a" : about 1 second
"b" : within 10 seconds
5) Perform "DTC CHECK" and confirm that normal DTC (DTC
3
1
No.12) is displayed and not malfunction DTC.
4
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-9