Air Cleaner Assembly Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect MAF sensor connector (1).
3) Remove EVAP canister purge valve (2).
4) Remove air cleaner assembly (3) with air suction
hose (4).
Installation
Reverse removal procedure noting the following.
• Tighten EVAP canister purge valve bracket bolt to
specified torque.
Tightening torque
EVAP canister purge valve bracket bolt: 5 N·m (
0.5 kgf-m, 4.0 lb-ft)
S7RW0A1406004
1
2
4
3
I5RW0A140004-02
Cylinder Head Cover Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove air cleaner assembly with air suction hose
referring to "Air Cleaner Assembly Removal and
Installation".
3) Remove cylinder head upper cover (1).
4) Remove ignition coil assemblies with high-tension
cord from cylinder head cover referring to "Ignition
Coil Assembly (Including Ignitor) Removal and
Installation in Section 1H".
5) Remove oil level gauge (1).
6) Disconnect PCV hose (2) from PCV valve (3) and
disconnect breather hose (4) from cylinder head
cover.
7) Remove cylinder head cover mounting bolts in
numerical order ("1" through "7") as shown in figure.
8) Remove cylinder head cover (1) with cylinder head
cover gasket (2) and spark plug hole gasket (3).
Engine Mechanical:
1D-11
S7RW0A1406005
1
I5RW0A140005-01
I2RH0B140033-01
I6RS0B141004-01