Dtc Clearance - Suzuki Grand Vitara 2011 Manual

Without Using Scan Tool (Vehicle Equipped with
Diagnosis Connector)
1) Turn ignition switch to OFF position.
2) Using service wire, ground diagnosis switch terminal
(1) of diagnosis connector (2).
3) Turn ON ignition switch and check DTC displayed on
odometer (3) of combination meter.
When more than 2 DTCs are stored in memory,
blinking for each DTC starts with the smallest DTC
number in increasing order. Also, DTC is indicated
repeatedly until the ignition switch is turned OFF or
disconnect service wire.
NOTE
When no DTC is detected, display on
odometer of combination meter is "0000".
4) After completing the check, turn ignition switch to
OFF position and disconnect service wire from
diagnosis connector.
Engine General Information and Diagnosis: For Petrol Engine Model 1A-32
3
1
2
I5JB0A110020-01

DTC Clearance

Using Scan Tool
1) Connect SUZUKI scan tool or OBD generic scan tool
(Euro OBD model) to data link connector in the same
manner as when making this connection for DTC
check.
2) Turn ignition switch OFF and then ON.
3) Erase DTC and pending DTC according to
instructions displayed on scan tool. Refer to scan
tool operator's manual for further details.
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector.
NOTE
DTC and freeze frame data stored in ECM
memory are also cleared in the following
cases. Be careful not to clear them before
keeping their record.
• When power to ECM is cut off (by
disconnecting battery cable, removing
fuse or disconnecting ECM connectors).
• When the same malfunction (DTC) is not
detected again during 40 engine warm-up
cycles. (See "Warm-Up Cycle" of "On-
Board Diagnostic System Description: For
Petrol Engine Model".)
Without Using Scan Tool
1) Turn ignition switch to OFF position.
2) Disconnect battery negative cable for specified time
below to erase diagnostic trouble code stored in
ECM memory and reconnect it.
Time required to erase DTC
Ambient temperature
Over 0 °C (32 °F)
Under 0 °C (32 °F)
S6JB0A1114004
Time to cut power to ECM
30 sec. or longer
Not specifiable.
Select a place with higher
than 0 °C (32 °F)
temperature.