Suzuki SX4 Service Manual page 192

Hide thumbs

Advertisement

Table of Contents
1A-142 Engine General Information and Diagnosis:
DTC Troubleshooting
NOTE
Before this troubleshooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
Starter signal check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Start engine, measure voltage between "C01-48"
terminal of ECM connector and vehicle body ground.
Is voltage 0 – 1 V?
3
Wire circuit check
1) Disconnect starting motor control relay in individual
circuit fuse box No.1 with ignition switch turned OFF.
2) Check for proper connection to starting motor control
relay at "RED/WHT", "RED", "WHT", and "YEL/GRN"
wire terminals.
3) Disconnect connector from starting motor.
4) Measure voltage between "C01-48" terminal of ECM
connector and vehicle body ground with ignition switch
turned ON.
Is voltage 0 – 1 V?
4
Wire circuit check
1) Measure voltage between "RED/WHT" wire terminal of
starting motor control relay connector and vehicle body
ground with ignition switch turned ON.
Is voltage 0 – 1 V?
Action
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00". If OK, substitute a
known-good ECM and
recheck.
Go to Step 4.
Check starting motor
control relay. If OK,
substitute a known-
good ECM and recheck.
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.
"YEL/GRN" wire is
shorted to power circuit.
If wires are OK,
substitute a known-
good ECM and recheck.
Faulty ignition switch,
check ignition switch
referring to "Ignition
Switch Inspection in
Section 9C".
If ignition switch is OK,
check for short circuit
between ignition switch
and starting motor
control relay to power
circuit.

Advertisement

Table of Contents
loading

  Also See for Suzuki SX4

Table of Contents