Front Wheel Speed Sensor Removal And Installation; Front And Rear Wheel Speed Sensor Inspection; Rear Wheel Speed Sensor Removal And Installation - Suzuki Grand Vitara 2011 Manual

Front Wheel Speed Sensor Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Disconnect front wheel speed sensor coupler (1).
3) Hoist vehicle and remove wheel.
4) Remove harness clamp, clamp bolts (2) and
grommet (3).
5) Remove front wheel speed sensor (4) from knuckle.
CAUTION
!
• Do not pull wire harness when removing
front wheel speed sensor.
• Do not cause damage to surface of front
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
3
1
2
Installation
1) Check that no foreign material is attached to sensor
(1) and mating encoder (2).
2) Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Front wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing front wheel speed
sensor.
3) Check that there is no clearance between sensor
and knuckle.
S6JB0A4506005
(b)
[A]
[A]: OK

Front and Rear Wheel Speed Sensor Inspection

Check sensor for damage.
If any malcondition is found, replace.
4
I5JB0A450029-01
Rear Wheel Speed Sensor Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Disconnect rear wheel speed sensor coupler (1).
3) Hoist vehicle and remove wheel.
4) Remove harness clamp (4) and clamp bolts (2).
ABS:
(a)
[B]
2
2
[B]: NG
4E-41
1
2
I5JB0A450030-01
S6JB0A4506006
I5JB0A450031-01
S6JB0A4506008