Rear Wheel Speed Sensor Inspection; Front Wheel Speed Sensor Ring On-Vehicle Inspection - Suzuki Liana RH413 Service Manual

4E-40 ABS:
Installation
Reverse removal procedure for installation noting the
following.
• Check that no foreign material is attached to sensor
and ring (1).
[A]
[B]
[A]: For 2WD vehicle
[B]: For 4WD vehicle
• Be sure to install wheel speed sensor (2) and its bolt
at the correct (upper) position as shown in figure.
Tighten sensor bolt (1) to specified torque.
Tightening torque
Rear wheel speed sensor bolt ((a)): 23 N·m (2.3
kgf-m, 17.0 lb-ft)
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing rear wheel speed
sensor.
• Check that there is no clearance between sensor and
knuckle.

Rear Wheel Speed Sensor Inspection

• Check sensor for damage.
• Measure resistance of sensor.
1
Front Wheel Speed Sensor Ring On-Vehicle
Inspection
1
• Check ring for being missing, damaged or deformed.
• Turn drive shaft and check if ring rotation is free from
I3RH0A450025-01
• Check that no foreign material is attached.
If any faulty is found, repair or replace. Refer to "Front
Drive Shaft Assembly Removal and Installation in
Section 3A".
I2RH01450060-01
Between both terminals (1) of sensor
1.2 – 1.6 kΩ at 20 °C (68 °F)
Between sensor terminal (1) and sensor body (2)
Infinity (∞)
If the check result is not as specified and any
malcondition is found, replace.
eccentricity and looseness.
S3RH0A4506010
I3RH01450052-01
S3RH0A4506011
I2RH01450053-01