Rear Wheel Speed Sensor; Output Voltage Inspection - Suzuki Ignis Service Manual

5E-38 ANTILOCK BRAKE SYSTEM (ABS)

REAR WHEEL SPEED SENSOR

3
1. Left rear wheel speed sensor
2. Right rear wheel speed sensor
4
2
3. Trailing arm
4. Sensor ring

OUTPUT VOLTAGE INSPECTION

1) Turn ignition switch OFF.
2) Remove rear seat referring to Section 9.
3) Turn over floor carpet.
4) Hoist vehicle.
5) Disconnect connector of wheel speed sensor.
6) Connect voltmeter between connector (1) terminals.
7) While turning wheel at a speed of approximately 1/2 rotation
Output AC voltage at 1/2 to 1 rotation per second
2WD vehicle : 85 mV or more
4WD vehicle : 106 mV or more
8) If measured voltage is not as specified, check sensor, rotor
1
3
to 1 rotation per second, check AC voltage of sensor.
and their installation conditions.