Tekelec IP7 Secure Gateway Administration Manual page 549

Database Administration Manual - IP7 Secure
Gateway
The alhost=none parameter removes the alternate local host from the specified association,
which also removes the multi-homed endpoint capability.
If the uaps parameter is not specified with the chg-assoc command, and the adapter
parameter value is being changed to either m3ua or sua, the uaps parameter value defaults to
UA parameter set 10 (uaps=10).
The port parameter can be used in place of the link parameter to specify the signaling link
assigned to the association.
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CHG-ASSOC: MASP A - COMPLTD;
Note: If the value of the open parameter was not changed in
Step 14.
13. Change the value of the open parameter to yes by specifying the chg-assoc command with the
open=yes parameter.
For this example, enter this command.
chg-assoc:aname=assoc2:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CHG-ASSOC: MASP A - COMPLTD;
14. Verify the changes using the rtrv-assoc command specifying the association name specified in
Step 12 Step
and
For this example, enter this command.
rtrv-assoc:aname=assoc2
This is an example of possible output.
rlghncxa03w 09-05-28 09:12:36 GMT EAGLE5 41.0.0
ANAME assoc2
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
ASNAMES
as1
IP Appl Sock table is (8 of 4000) 1% full
Assoc Buffer Space Used (650 KB of 800 KB) on LOC = 1205
910-6278-001 Revision A, January 2012
13.
1205 IPLNK PORT
M3UA VER
m3ua1
m3ua2
gw200.nc-tekelec.com
---
2048 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
YES ALW
as4
IETF M3UA and SUA Configuration Procedures
Step 3, continue the procedure with
A LINK
M3UA RFC
3000
2 BUFSIZE
120 RMAX
3000 UAPS
YES RTXTHR
as6
A
250
800
10
10000
549